View RSS Feed

optikalefx

mp3carís Robert Wray interviews GENIVIís board member Joel Hoffman

Rate this Entry
by , 06-04-2009 at 06:05 PM (10936 Views)

Embed this video


mp3car's Robert Wray interviews GENIVI's board member Joel Hoffman in a 2 part interview.
Part 1 of 2 covers:
What is GENIVI, How did it start?
What are the first topics GENIVI will address?
What is the Link between GENIVI, Linux and Moblin?
What are the costs?

Embed this video


Part 2 of 2 covers:
What actually is the GENIVI scope?
What areas do you expect to cause conflict and how will association conflict be handled?
Why are parts of development closed?

Submit "mp3carís Robert Wray interviews GENIVIís board member Joel Hoffman" to Digg Submit "mp3carís Robert Wray interviews GENIVIís board member Joel Hoffman" to del.icio.us Submit "mp3carís Robert Wray interviews GENIVIís board member Joel Hoffman" to StumbleUpon Submit "mp3carís Robert Wray interviews GENIVIís board member Joel Hoffman" to Google

Updated 06-18-2010 at 12:45 PM by optikalefx

Categories
Technology Events

Comments

Leave Comment Leave Comment
View Thread

Last 3 Posts

[media]http://vimeo.com/5086806[/media]

Goce from mp3Car will walk you through the steps necessary to power your laptop using only the p2140 and the wire your laptop power adapter came with.

-For this project you need the following materials:
-p2140 and 8pin molex output harness
-Wire strippers 14-22 gauge
-Bench battery
-Multimeter
-Shrink tubing and heat shrink tubing gun OR electrical tape
-Solder gun and non leaded solder
-laptop and its power brick
-knife or scissors

The basic procedure here is to cut and strip the laptop power brick, while NOT cutting the multi-strand wires right beneath the black plastic. Then soldering the positive wire of the primary output from the p2140 to positive end of the now cut power brick cord. And then the same for the negative.

In the next video we will show you how to test the polarity using continuity and then actually test turing on the laptop using only the power from the p2140 (through the bench battery of course)