Jensen2000
Car Computer Install: Wiring The Amplifier Overview
by , 12-14-2011 at 03:15 PM (8693 Views)
Sean Clark, from mp3Car, shows us how to connect the amplifier in your vehicle, an essential component to any car computer install. The 12 volt positive power cable is wired directly to the positive terminal on the battery, with a fuse in line as close to the battery as possible. The negative wire is also run directly to the battery to prevent noise from being introduced into the system. The ACC wire and the speaker wires are connected to the factory wiring harness using an adapter made specifically for this vehicle purchased on the web.
- Categories
- How To Videos , How To Build & Install A Car Computer
Email Blog EntryComments
Leave Comment
View Thread
Last 3 Posts
I agree.... He needs to put a grommet on there. I recommend the one I use, and you guys probably sell. Also its not a big deal where he ran the cable, because remember the big plastic/rubber flap in the wheel well is going to cover it OBD2That's a nice car.Most of features are available in this car which is very important for car maintenance.Yeah I understand that's why I said I have no experience with that particular car. I just would of had a hard time doing that on my own car lol.
Go to Profile
Mark as Read
