Thread: Enhanced Graphics mode

Not sure if this is the only thing, but I noticed smoother animated transitions between screens. Very subtle, but it's there.

Originally Posted by Nola111

Not sure if this is the only thing, but I noticed smoother animated transitions between screens. Very subtle, but it's there.

That's the only thing I've noticed also.

Originally Posted by SKiTLz

What kinda hardware you guys running? Im on a 2.0GHz C7 w/ 1GB RAM and onboard video.

It seems to run fine but I have it disabled anyways. I like a snappy interface.

I am also on a 2.0GHz C7 and onboard video but w/ 512MB RAM.


How have you disabled enhanced graphics?

I'm using a VIA EX with a C7 1.5GHz, 512MB of RAM with 128 shared with on-board graphics. CF 2.0 runs really well with the enhanced graphics mode. Even the visualizations work well.

One thing i have noticed, may be should be in a different thread. But have any of you guys gone back into the settings for likes of general and audio/video. Coz when i go into them now, half the options do not appear and there is only one settings page inside both.

I only got to have a brief play, but would like to know if anyone else has noticed it.

Originally Posted by AlienEclipse

I'm using a VIA EX with a C7 1.5GHz, 512MB of RAM with 128 shared with on-board graphics. CF 2.0 runs really well with the enhanced graphics mode. Even the visualizations work well.

Did you change a setting in the BIOS or does it by default use 128MB?

Originally Posted by AlienEclipse

One thing i have noticed, may be should be in a different thread. But have any of you guys gone back into the settings for likes of general and audio/video. Coz when i go into them now, half the options do not appear and there is only one settings page inside both.

From the release notes:

Originally Posted by veetid

* Settings are now defaulted to show the Basic Settings mode. Advanced Settings can be enabled in 2 ways. To enable Advanced Settings temporarily, hold down the "+" button in the Main Settings Screen for 8 seconds. To permanently enable Advanced Settings, similar to older version of CF, pass the -advsettings command line option when starting Centrafuse.

Thanks,
David and the Flux team!

Originally Posted by Lazyflip

Did you change a setting in the BIOS or does it by default use 128MB?

I set it in the BIOS to use 128MB, yes.

And yeah, i forgot about the advanced settings mode.