MP3Car.com case badges are here! $1 each

**ShinkunoNamida** · 09-11-2003, 02:03 PM

NO LONGER AVAILABLE.

Sorry folks, I have to close up shop here, I've taken a new job and won't have the equipment available anymore. When I finish shipping out the current orders I'll post the counts of what I have left. It'll be first come first serve. I may just send what I have left to ziplock for him to decide what to do with.

mp3car.com case badges are going on sale! They are $1.00 each including, plus $0.75 additional shipping if you live outside the US.

The case badges are standard 1x1 inch (1in = 2.54cm).

please visit [url removed]and use the shopping cart to submit your order via paypal.

alternatively you may print out the shopping cart, and send me an envelope with your prefered payment method (personal check or cash) be advised, that sending money takes longer, and of course shipping cash is NEVER a good idea.

Also keep in mind I am personally making these things. I am making a couple hundred, but if I need more I'll make more. Please don't order outrageous ammounts of badges (where are you going to put 50 badges anyway??)

DO NOT REPLY TO THIS THREAD WITH AN ORDER!! FOLLOW INSTRUCTIONS! I will delete any post that comes in this thread that asks for an order. If you have any questions or comments feel free to ask, but don't post here with "I want 5!"

I will do my best to produce enough for everyone, but if I fall behind I'll post a note letting you guys know. I don't forsee this being a problem though.

**dscustoms** · 09-11-2003, 05:50 PM

Yo Shink... Can you get them made in a nice extruded aluminum? Then we could have mp3car car badges!!!

Dave

**ShinkunoNamida** · 09-11-2003, 06:02 PM

That would be nice

I'm sure I "could" but I'm sure nobody would be willing to pay either. I just happened to come up with a fairly painless way to make these things that looks pretty decent. A nice embossed aluminum might be nice too

with the MP3car.com all sticking out.

**gizmomkr** · 09-11-2003, 10:44 PM

So exactly what material / process are they ?
(flat sticker, raised gell type bubble, Etc)

**ShinkunoNamida** · 09-11-2003, 11:36 PM

they are flat, but they are thick and hard. I would estimate that they are almost a 1mm thick. I "could" make the bubble stickers, but that is more expensive and FAR more time consuming.

They are laser printed so the image is very crisp. Once I produce a couple (I have only produced a different design that I have used for my own purposes) I'll post a few photos here.