FS: DWW-7VGA (Lilliput) disassembled (USA)

**tom2112** · 12-30-2005, 12:11 PM

I have a DWW-7VGA (that's the in-dash, non-motorized, 7" vga) that I was in the process of rewiring it with a flat-flex cable (replacing the big fat non-bendy-type cable that went from the monitor back into the in-dash section).

I just haven't had time to finish my work on it and I'm tired of looking at it sitting on my workbench. I will post pics so you can see what I've done to it. The monitor was in perfect working order before I started working on it. Since the wires are disconnected, I can't verify that it works. I will say that I have no doubt that it still works, since all I've done so far is cut the main cable. But, I cannot guarantee that you are a good enough with electronics and soldering to finish the job. So, I am selling it "As Is". I will pack it up, along with everything that came with it originally (cables, PSU, remote, driver CD, etc.), and all of the parts that I bought for it (the flat flex cable, the sockets, the ferrites, etc.) and ship it to you.

All I want for it is $150 plus shipping!!!

The housing (without the Lilliput is $100 alone, so you're getting a Lilliput for $50 and some work on your part). Armen from DWW did the installation of the Lilliput into the housing, so you know it was done right.

I'll ship it anywhere in the world - what do I care, you're paying shipping.

Edit: Pics are coming! I have to go home from work first!

**Motorcity** · 12-30-2005, 12:28 PM

sold! pm sent

**tom2112** · 01-03-2006, 08:56 PM

This is the in-dach housing.

**tom2112** · 01-03-2006, 08:57 PM

Housing half closed

**tom2112** · 01-03-2006, 08:59 PM

Back of the LCD. You can see where I have cut the vga, usb, power, and video wires, in preparation to rewire them with a flat flex cable.

**tom2112** · 01-03-2006, 09:01 PM

Here is the front of the LCD and a pic of some of the wiring. You can see where I have removed the touch screen / video in connector in prep to be replaced by the other flat flex cable.

**tom2112** · 01-03-2006, 09:02 PM

Here are the flat flex cables and the ferrites I was planning to use. There are a couple lengths as I hadn't decided which would work best.

**tom2112** · 01-03-2006, 09:03 PM

Conspicuously absent is a pic of the VGA cable, the remote, the drivers CD, and the box. I can't find them right now, but I'm sure they're around. So I'll keep digging.

I seriously doubt that I will find the little screws that hold the bezel onto the housing. In fact, if I remember right, I never got them from Armen in the first place. I didn't care, since I wasn't planning on using the bezel. The bezel can be seen in the lower right of post/pic #4