Thread: FS: carPC - M2-ATX Mini-ITX w/Morex 5677 Case & Xenarc 10.2" Touchscreen & Bench PSU

I am selling my car computer setup (MONITOR SEPARATE! - See below). I never finished this project, and the SSD I bought for it went south shortly after I purchased it. The unit powers up and I can access the bios easily.

Included:

Case: Morex 5677 Mini-ITX Case - Two built-in cooling fans, Added Heyco grommet and quick release power cable.
PSU: Mini-Box M2-ATX 160W DC-DC Power Supply Unit - Controls the on/off switch of a motherboard depending on ignition status, Wide input, 6v to 32v (survives cranks), Built-in shutdown controller, monitors battery voltage level preventing deep discharge
Mother Board: Intel D945GCLF2D Mini-ITX Motherboard with Integrated Atom Processor, 45nm Dual Core Atom Processor 330 integrated (1.6 GHz / 512 KB L2 Cache / 533 System Bus) Chipset 10/100/1000 lan, 8 USB ports (4 back, 4 headers), Realtek ALC662 audio codec (5.1 channel HD audio)
Memory: Buffalo 2Rx8 DDR2 SDRAM 2GB 800MHz
HD: Intel 80GB SATA II Solid State Drive (SSD) - POSSIBLY DEAD!!!!
Other: MP3Car USB SuperSize Pack, 12" Red SATA II Cable w/ Locking Latch, Corsair DDR2 2GB PC5300 RAM.

Asking $200 Shipped!

Also For Sale:

I'm selling my Xenarc 10.2" Touchscreen Monitor 1020TSV. It was produced in 2008. It has never been installed in a vehicle and has very few hours on it. I only used it on my work bench while I was building my computer. I never had a chance to to install the drivers and check the touch screen, but I am assuming it works as does everything else with this monitor.
Includes AC adapter, DC cord, VGA/USB/Audio cable, weighted mounting base, mounting bracket, mounting hardware, remote control, driver CD, screen protector and associated paperwork in original box.
Asking $350 Shipped.








Also For Sale:

My custom made Bench Power Supply Unit. Input: AC 100~240V 50~60Hz, Output: 12V, 8A, Max 100W. Works great! Asking $35 Shipped!