Thread: F/s:*** Fully Assembled car PCs in Voom PC-2 cases***

Originally Posted by explicitgst

pm sent =)

It says your PM inbox is full.

PM sent

Mine showed today, shipped fine. Wanted to look inside, however I cannot guess how to get the front faceplate off. Anyone know the trick? I downloaded the manual however it only shows the front panel installed, and I can only see 2 bottom side tabs/slots to loosen the faceplate. There are 2 more slots placed to the sides of the cdrom slot however I don't know how to access them.

I want to wire in an USB Audiophile DAC to the RCA audio instead of motherboard header audio, and the USB DAC I have is a small, 1" x 1.5" low profile board, so there should be plenty of space for it inside.

Thanks, Robert.

On the voom case here I just pull on it and it comes off pull up on the bottom first should popout abit then pull off. SNO

Pm sent.

Originally Posted by SNOtwistR

On the voom case here I just pull on it and it comes off pull up on the bottom first should popout abit then pull off. SNO

Thanks Sno, I wiggled and pulled and it finally came off ok. I was worried about breaking those 2 upper tabs but they came out fine. It looks like the memory card is high quality 85c rated Hynix, so I am ordering another of those for 4GB total. And there is plenty of space for my DAC.

All PMs replied to!

Originally Posted by trunite2098

PM sent

It says your PMs are full, heres the right tracking number 1ZV532450306035650 Sorry about that!

Ray,

If I may ask where you found those memory modules, and how much? A google search did not find the -c, which I assume is the high temp. And it figures, I broke off one of the little tabs, I hope it doesn't rattle....