Cruise Control Module Address?
Wanted to start off by thanking this site for being around. Lots of threads here helped me get started on my little project to interface an arduino based obd2 reader to my RX8's lcd screen.
I was looking to take this project even further, and map the controls to the steering wheel cruise control buttons. I assume that the buttons are linked to the CANBUS but I have no idea how to figure out exactly where the module is on the bus. My idea is to have
"Cancel" - switch modes if cruise control is off
"Accel" - Previous monitor if cruise control is off
"Decel" - Next monitor if cruise control is off