Renault Megane 1999 ODB-II
after reading this obd section i have been intrigued with the idea of ODB output to my carputer, as it is i have a 1999 Megane Coupe which is almost carputer complete. i was curious so had a browse under the ashtry and then the fusebox and was shocked to see that the OBD exists. (i think)
after reading roverron's post
i have decided to purchase digimoto's ElmScan Interface (With Enclosure)
5th one down at http://www.digimoto.com/order.htm
i have looked at the pin layout and noticed that pin layouts are as follows:
Pin 1 metallic contacts (there but not required?)
Pin 3 metallic contacts (there but not required?)
Pin 4 metallic contacts (for iso)
Pin 5 metallic contacts (for iso)
Pin 7 metallic contacts (for iso)
Pin 11 metallic contacts (there but not required?)
Pin 15 metallic contacts (for iso)
Pin 16 metallic contacts (for iso)
ISO 9141-2 – The connector will have contacts in pins 4, 5, 7, 15, and 16
i take my ODB-II is then of an ISO format.
can anyone confirm that it is the ISO interface i need!
as i have to purchase from UK.