Going to 'dump' another PM in here as it relates to similar subject and should available to others.
Originally Posted by amk136
OK, that thing is bit of a bugger to play with.
Basically there are four philips screws behind it holding it in place round the back, plus two which hold it into the airvent
First of all remove the two screws that screw it to the air vent above.
there are now two screws to each side of it.
If you look at the pics of one taken out you will get an idea maybe.
these are some photos which will be the base of a tutorial I am putting together.
You should notice the extra pieces down the sides which have the screw holes. You will need a small stubby philips head screw driver.
It will probably be best to remove the OBC and the sunglass holder so you can reach up and behind.
Also have some plasters/bandaid ready coz you are more than likely going to scuff your fingers/back of hand.
You may also find in necessary to break the middle horizontal section, this is not really a problem as you will propably need to remove it anyway to fit the screen on later.