need some fiberglass help on wrapping my tablet install.
I am almost to the point of wrapping and glassing the outside of my tablet install. I still need to get the volume and tuning knobs in place (bottom left and right side). I want to use a thinner fabric to wrap it because I do not want to add a lot of thickness to the edge since this fits in a cutout in my car. I can later add fiberglass from the inside to keep it strong.
My question is what is the best way to make sure I get a good bond to all the black plastic pieces. Should I use a spray adhesive so the fabric sticks to all the parts and apply resin over top? Also for the two knobs I need to keep that circle area clean otherwise I will not be able to get them back on, should I just use blue tape?
Any other tips or suggestions would be greatly appreciated thanks!