2000 intrepid is done any suggestions on improving bezel
Hi all, here is my somewhat finished touchscreen untill i redo in a month or so...I started yesterday finished today.i know,i know i get what i asked for when i wanted it done in a 24 hour period but don't think it is that bad for very first time fabricating anything and painting too.
Suggestions on my redo please...
My big problem i am going to have is cracking and also straighten out the right side it is sticking up. I just used straight bondo.In the picture it does not show the filler in the 2 holes on the side of the monitor but i did fill them with plastic before using bondo (just so you know).
what would be the best way to stop cracking on this one or prevent cracking on my redo?
i know lots of you use fabricators use fiberglass, fiberglass mats etc...
but it seems like to much fiberglassing for such little spots i need to fill. I did not put bondo on thick at all.The bezel is flimsy because i cut out all the supports.
should I of filled with epoxy insted? how is epoxy to sand?
Is this one fixable or should I redo from scratch? If so how?
thanks for your comments and suggestions