If (voltage < threshold && variable > 0), then varaible = 0 and send key B.
If (voltage > threshold && variable == 0), then send key A.
if voltage < threashold, then variable = 0
that is psuedo code. Use the configurator and make that. Each if is a logic module. Each then is a then do.
which pin on the analogue header is power and which is ground? which color wire do you attach to the steering wheel resistive wire behind the radio?
lol sounds complicated.. so each one of those will be in its own tab just like A B C in the original tutorial?
PS. i know i am going to end up asking this later on so let me get it out the way now.... How would i combine both codes into one XML.. I am assuming i would have to create another input and just keep creating tabs then save the entire thing as one XML.. Steering wheel and Reverse Cam Code all together?
in FB the Input is the one furthest from the center.. the middle one is ground. (the inner one is 5v but you will not be using this unless you need voltage divider C from the voltage divider section)
For me the rem control and rem ground are pink and brown respectfully. I am not sure if the accord follows the same color though.. i would do a search on the12volt.com or google the wiring harness color code
lol youve already answered your question. take a look at your post
the red/green will be your input (from the looks of those values you would not need a voltage divider. i could be wrong tho)
Connect the center of the FB input (ground) to a ground point in your car. and BAM you should be set
Im having the same problem too. its save in the XML but when re opening the XML its does not show it in configurator..
Are the values for my car the same as the one in the Civic Post? lol can you confirm?