No announcement yet.

aftermarket gauges installation

  • Filter
  • Time
  • Show
Clear All
new posts

  • aftermarket gauges installation

    hello, i need help with gauges.
    i have a 2003 accord coupe ex v6 auto.

    i re-located my cluster with a screen. don't flame. the setup is satisfying for my plan. but now i need the last part which are the car's reading:
    engine temp, fuel level, rpm, speedo

    can someone give me a crash course on installing the gauges.
    i have odb2 usb adapter but wasn't satisfy with the quickness and my car apparently lack fuel level readout.

    can i tap into my re-located cluster to get the read out for all the gauges? if so how do i know which wire/pin to tap for which gauge.

    or can i tap into the ecu instead? i have a copy of my ecu diagram.
    doens't say anything about fuel level =\

    i dont' really want to run each sensor for each gauge.

    does my car already have a sender unit for each gauges?
    should i look for electronic or mechanical?

    please help this is the last obstacle for my carpc setup.