Announcement

Collapse
No announcement yet.

Is this an good OBD2 Interface ?

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Is this an good OBD2 Interface ?

    Hello I am thinking about ordering this OBD2 Interface
    http://www.centauri.dk/mp3car/obd2-102.pdf
    But can someone tell me if thatís a good choose?
    I need it for my Ford Focus 1.6 from 1999.
    The Interface should support 11 protocols. ISO (ISO9141-2), KWP2000 Fast (ISO14230-4), KWP2000 Slow (ISO14230-4), PWM (SAE J1850), VPWM (SAE J1850), K/L og KK/L.
    CAN-Bus 11Bit/250kBaud (ISO15765-4), CAN-Bus 11Bit/500kBaud (ISO15765-4), CAN-Bus 29Bit/250kBaud (ISO15765-4), CAN-Bus 29Bit/500kBaud (ISO15765-4).
    The price is about 105 $.

  • #2
    I have seeen this previously, also would this work with my ford fiesta 2002 mk6?

    Comment


    • #3
      Not a bad price for a muliprotocol scantool, still our scantool www.obdpros.com supports all the protocol at a much lower price $ 84.99 and supports speeds upto 1.2 Mbits and will also work with all the ELM327 software including PCMScan, OBD 2007 & Scanmaster for ELM

      Thanks
      Paul

      Comment


      • #4
        Yeah, you'll run into problems finding software for that interface, the obdpros.com interface has alot of software written for the chip it's based off of.
        "stop with the REINSTALLS, what do you think we got some lame-o installer!!!" - mitchjs
        RevFE
        My Shop

        Comment


        • #5
          Why should i get problem finding software for that interface ? because the write “Software compatible to most of software for ELM32x Chips from ELM Electronics
          (OBD-DIAG, C.E.S. spezial Edition, Scantool, Digimoto, OBD-ScanMaster, wOBD, Real Scan, Scan-Test, OBD Gauge for Pocket
          PC, OBD2ScanTool)”

          About the price, the OBDPro USB Scantool cost 85$ but since I live in Denmark, the normal shipping cost for he is about 30 $ so the price will be the same. Since my price for the other interface is including shipping to Denmark.

          And my plan is to write my own software over the time, sut to start with its always good to have some other to se how it works and analyzing the protocol.

          Comment


          • #6
            In that case ignore my previous comment about the software, I missed that line in the datasheet. TBH I've never heard of the AGV4000 chip and oddly can't find any information on it, so I can't really say about the quality.
            "stop with the REINSTALLS, what do you think we got some lame-o installer!!!" - mitchjs
            RevFE
            My Shop

            Comment

            Working...
            X