Announcement

Collapse
No announcement yet.

power good signal - help me please!

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • power good signal - help me please!

    My Super 7 motherboard with an ETEQ chipset (now VIA) needs the power
    good signal to operate. I have an Arise 865V DC-DC PSU that does not have
    the PG signal. I've tried just tying the +5V to the PG pin (I did it by
    soldering on the back of the MB, is that okay??) but it did not work. I also tried a 4.7 K resistor between +5V and the PG as suggested by members of this board in the archives. I did the same thing, just soldering them to the back of the motherboard. Sproggy mentioned something about a capacitor to ground... how does the that fit in? Where do I have to solder all the leads? Thank you!

    Nate

  • #2
    What I did was just take a small piece of wire and jam it into the adjacent +5v and ground

    Comment


    • #3
      Originally posted by mprover:
      What I did was just take a small piece of wire and jam it into the adjacent +5v and ground
      Thanks for the reply. Sproggy sent me a crude circuit with a resistor and capacitor that did the trick. What a finicky MB!

      Nate

      Comment

      Working...
      X