Announcement

Collapse
No announcement yet.

Got my parts.. tips on assembly?

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Got my parts.. tips on assembly?

    is there anywhere on the site that would give good directions on how to or at least give some suggestions on how to assemble the pc?

  • #2
    It would help if you gave a wee bit more info...
    2006 Lancer Evolution IX MR In-Dash PC Project - WIP

    Planning:
    [----------] 100%
    Purchasing:
    [----------] 90%
    Installation/Fab/Assembly (Revised v2):
    [----------] 90%

    Comment


    • #3
      Western Digital Scorpio WD1600BEVS 160GB 5400 RPM SATA 1.5Gb/s Notebook Hard Drive

      Kingston ValueRAM 1GB 240-Pin DDR2 SDRAM DDR2 533 (PC2 4200) Desktop Memory Model KVR533D2N4/1G

      Intel BOXD201GLY2A Intel Celeron 220 SiS 662 Micro ATX Motherboard/CPU Combo

      then getting an extra fan for cooling.. i have an OLD IBM THINKPAD cd/dvd i would like too use if i could as well.

      Comment


      • #4
        No casing? You'll need something to gather those bits into
        2006 Lancer Evolution IX MR In-Dash PC Project - WIP

        Planning:
        [----------] 100%
        Purchasing:
        [----------] 90%
        Installation/Fab/Assembly (Revised v2):
        [----------] 90%

        Comment


        • #5
          http://www.google.com/search?hl=en&q...+assemble+a+pc
          2003 Nissan Xterra Worklog

          Total amount spent so far: $1196.64

          You will probably spend AT LEAST 2x what you initially budget for your CarPC Project!

          2003 Nissan Xterra - Modifications

          Comment


          • #6
            check out my picture on ebay. i mounted my setup "open" mobo was mounted to a piece of plexi glass and cooling is obviously better this way.

            Comment

            Working...
            X