Announcement

Collapse
No announcement yet.

OCZ SSD drive kills my GPS Signal !!!

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • OCZ SSD drive kills my GPS Signal !!!

    Hi All,

    I'm using a SkyTraq Venus 6 Chip with an active antenna.
    Before adding the SSD my PGS reception was very good and the Venus chip would lock in 9 seconds. I added the SSD as a system disk and kept the 500GB standard HD and GPS would not get a fix at all. If I move the antenna out of the car and away from the trunk I get signal. I disconnected all devices and kept the SSD connected (otherwise I can't test !!). still no clue to what was killing my signal. then I went back to basics: what has changed since the last time my GPS was working : the SSD. I disocnnected the SSD and there you go full GPS signal (the chip signal LED was flashing like crazy !!!) !!!!
    Any idea how to isolate the SSD interference. I don't want to throw away a new SSD :-)
    Note: I don't get a gps signal if I keep the antenna inside the car, even if I take it to the front of the car.

  • #2
    I have a feeling there is an issue with the grounding on the OCZ SSD drives.

    I could not nail down my filthy FM radio interference, tried moving cables everywhere, nothing seemed to improve the interference problems.

    I was installing a ground loop isolator on the line in, and my wrist pressed against the underside of the SSD, and my interference dropped to almost nothing. Pulled my hand back, it came back.

    I found that the chassis of the SSD isn't properly grounded, and because I had it mounted to an MDF board, it was causing havoc.

    Ended up running a ground wire from the base of the SSD case to common ground, and that solved it.

    Might be worth trying for yours, see if that fixes it, but it sounds like a similar issue, and if so, it would point to OCZ brand SSD's at the least having grounding issues.

    I'm actually planning on rebuilding my case for my car computer, and relocating the SSD to either a computer indoors (And pick up a new sandforce based SSD for the car), or alternatively, put it into a shielded case, with full grounding, and as far away as I can mount it!

    Comment


    • #3
      I noticed my old OCZ SSD made a high frequency whine. Either try grounding the main case of your SSD or possibly even taking a metal sheet or aluminum foil and making your own grounded shield. You may have to ground the GPS receiver's USB to the grounded SSD as well.

      Of course there is also the possibility that the high frequency whine is making its way through the power and data wires coming from the SSD and onto the traces of the motherboard, then it might be nearly impossible to fix.

      Comment


      • #4
        Thanks for the feedback guys. I will try grounding the case tonight and report back tomorrow.
        Just to understand it correctly, grounding the OCZ means wiring the case to a ground point in the car, right?

        Comment


        • #5
          Correct, for me, it was just crimping some ring terminals onto a wire, and using the screw mounts on the bottom of the OCZ drive to screw a ring terminal in place, then the other end onto the chassis of the car.

          Comment


          • #6
            grounded the OCZ SSD to the car chassis. still no gps signal. wrapped the ssd in aluminum foil. still no gps signal. I think I'm dealing with a radiactive disk here ! will call greenpeace :-)

            Comment


            • #7
              If its only new, return it as an RMA job.

              It doesn't work in the system it is installed in....see if they will take it back and get a new one.

              Comment


              • #8
                it's new but it will be hard to explain to the guys why i'm returning it!! I initially bought a gskill one which didn't work at all with XP. besides will another ssd not have the same effect? i will try to return/exchange it for an intel drive and report back

                Comment


                • #9
                  You can just tell them that you do audio processing on your computer, and the SSD was creating terrible interference on your analogue inputs, which no other component did.

                  Should be enough to show its faulty, so hopefully they should take it back

                  Comment


                  • #10
                    I had interference issues from my PC with my GPS unit. I never tracked it down, had to move the GPS unit to a different location.

                    Also, the screen cause interference as well. Same thing, had to move the GPS to get it to work.
                    Originally posted by ghettocruzer
                    I was gung ho on building a PC [until] just recently. However, between my new phone having internet and GPS and all...and this kit...Im starting to have trouble justfiying it haha.
                    Want to:
                    -Find out about the new iBug iPad install?
                    -Find out about carPC's in just 5 minutes? View the Car PC 101 video

                    Comment


                    • #11
                      I requested an RMA from OCZ and explained my issue. I'm waiting for their answer. In th emeeantime I'm einstalling Win7 on my old drive. will update you with the outcome of this issue.

                      Comment


                      • #12
                        it's been a wile but here is what happened since: OCZ refused to talk to me about this. They replied to one email and then dumped my emails to junk I guess. I got a samsung 256GB drive (1.8 format) which is performing very good.

                        Comment


                        • #13
                          I am very sorry for your troubles, however I must thank you. I bought a pyro ssd and couldnt figure out why my gps stopped working. I was going CRAZY! Untill I read your post. I am going to exchange mine for a samsung... Thanks again for sharing your experience.

                          Comment


                          • #14
                            you're welcome

                            Comment

                            Working...
                            X