Announcement

Collapse
No announcement yet.

Is there any way to get a 0-5 volt data signal from a GPS setup/unit?

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Is there any way to get a 0-5 volt data signal from a GPS setup/unit?

    Is there any way to get a 0-5 volt data signal from a GPS unit?

    I would like to be able to capture the speed of a gps unit in a 0-5 volt signal if possible.

    Does anyone have some ideas how this could be accomplished, or if there is available hardware out there to do this that can be linked to?

    Little obscure I know, but if anyone has some insight on how this can be accomplished please post your ideas or information.

    So essentially I need the data to be processed to a physical value/speed then outputted to a converter that will turn a value into a 0-5 volt signal.

    Are there things that are out there that can do this?

    Would I be better served placing this in the general hardware/software sections?

  • #2
    There's a guy on the MegaSquirt message board doing this, electronic speedo with NEMA interface.

    msefi.com

    Comment


    • #3
      I haven’t been over there for a while I will check them out.
      Thanks



      Are there any software and hardware interfaces that will turn data into a 0-5v signal?

      Comment

      Working...
      X