Announcement

Collapse
No announcement yet.

7" touchscreen calibration problems (tm-701)

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • 7" touchscreen calibration problems (tm-701)

    Hey, I was wondering if anyone can give me some ideas.

    My toucscreen was working fine but was just a tad bit off. No problem, I thought Id just recalibrate it and see if that helped.

    I can NOT complete the 4-point calibration. The first and second blinking circles have no problems and beep pretty quick. However I have rarely gotten the 3rd one to beep when holding it down (best luck with my thumb). It has not completed the 4th and final one though and because of this it fails everytime. It is definitely reading though because everytime I lift my finger it restarts but it never beeps. I cant even get halfway through the 25 point calibration.

    -Touchscreen was working fine prior to me trying to recalibrate it.
    -Touchscreen still seems to work, it just wont calibrate.
    -I have uninstalled/reinstalled the drivers (properly) more than once with no different results.

    Any ideas?

    Appreciate it.
    92 Taurus SHO - Daily driver - Epia M10000 80GB 512mb 7" touchscreen, Opus PSU etc

    93 Black SHO - 30mpg cruiser

    90 Silver SHO - 419whp fun/project car, CarPC to come (for tuning)

  • #2
    Had the monitor been opened?
    Opus case. MB 899 core duo 2.0ghz
    Dual vga out, 400 gb hard drive, Centrefuse front end
    zapco 1000.4 for zapco 6.5 componets
    zapco 1100.1 for 2 13" W6.

    Comment

    Working...
    X