OK here it is. I have wired up my first lcd. It is a Seiko L4034 4x40. I got power because there are blocks on the first and third lines. I have lcdprint. I run it and the first time it does not detect my lcd screen. Then I run it again and it detects it. I just type "lcdprint 378". Then I type "lcdprint 378 40 4 test.txt" and lcdprint does nothing. I still have the blocks on the lines and nothing else. Does the text file you are outputting to the screen have to be in any special place. I have mine in the same directory as lcdprint. That is in c:\. I am using Windows98SE. I can not get it to use any of the plugins that I have for winamp also. I have checked all of my wiring and the wires are connected to were they should be. I tested them with a continuity tester. The only thing that I found odd was that I could touch the +5 wire and a wire that is labled ground and I have a circuit. I do not know that much about electronics. Please help.
No announcement yet.
Nothing but blocks on 4x40