Announcement

Collapse
No announcement yet.

ENAB, and signal and DTMG

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • ENAB, and signal and DTMG

    Hi,

    i'm going to receive a Sharp LQ104V1DG11 screen, and i'm thinking of buying the EPAP-200 controler card ( ftp://www.datadisplay.de/Boards/epap-200_0800.PDF ).

    Ok, now my problem, i know all the pinouts and i know where to connect everything, i just have some doubts.

    In the controller card there is one pin DTMG that in the LCD datasheet does not apear.

    I the LCD there is ENAB, R/L and U/D that in the controller datasheet. does not apear.

    Question 1
    R/L and U/D is to control the reversing of the LCD. To have normal function R/L must be HIGH and U/D must be LOW so, i just have to connect R/L to VCC and U/D to GND to have normal functioning of the LCD, right?


    Question 2
    Is ENAB and DTMG the same thing? i think so, i just want a confirmation from someone who really knows, i don't want to frie my new LCD (isn't here yet but shouldn't take much longer).
    Shades

  • #2
    Anyone?

    Anyone confirmes my doubts?
    Shades

    Comment


    • #3
      Last try

      Come on, one of you guys must know this.
      Shades

      Comment

      Working...
      X