I know this is so simple I've been reluctant to ask, but after searching I haven't come across any direct answers. If I need to trim the opening of my Metra install kit to better accomodate an install, what is the best way to do so? With a utility knife, Dremel, lazer beam? Again, really simple, but as they say "measure twice cut once". I need to take off less than 1/4 inch, and I want to make sure it comes out clean the first time. The Metra Kit (95-3302) is just ever so slighty too small on the inside for the face of my Infill G4.
No announcement yet.
Question about best way to trim a Metra install kit