Announcement

Collapse
No announcement yet.

cnx-1900 generates 1 volt too much.

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • cnx-1900 generates 1 volt too much.

    Instead if 18/19/20 I am getting 19/20/21.

    Is this a configuration problem on my part?

    Stav

  • #2
    Haven't played with one, but maybe the voltage comes back down to within spec when there's a load on the supply?

    CarPC v2.5 up and running - all hardware installed, skin configured, and iG tweaked like crazy. Now for OBD-II, and voice control, and camera plugin, and... :nutz: - it never ends!

    Comment


    • #3
      I've read that they increase the voltage to make up for loss due to wiring. The the Carnetix site and read the manual - I think you'll find this there.

      Comment


      • #4
        read that too. But I remember it being like .4 or .5 volts.

        I would have liked a confirmation from the carnetix guys, but no response on they're forum either.

        Comment


        • #5
          What are you using it for?
          do you think it will matter if it is just a little high?

          Comment


          • #6
            Thinkpad, needs 16v, people have pushed up to 18, I would rather not be the trailblazer and run 19v and seeing what happened.

            Comment

            Working...
            X