Announcement

Collapse
No announcement yet.

Power Wiring Question

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Power Wiring Question

    I have the following two basic components: Carnetix P1290 and Travla C158 (w/ 90W built-in psu)

    They are both being shipped currently...my questions are:

    1. Will I need to purchase additional wiring to connect the two together?

    2. If so, what guage wires are recommended for power, ground, and ignition?

    3. Can I use the Travla's power cable and cut the end to connect it to my carnetix?

    4. If I do that, can I T-tap my screens's power cable to the case's?

    I appreciate any input you guys have...thanks
    PostCount++


    - SrCsTc's Bezel
    - Alpine W200/H701
    - ED Nine.2X
    - OZ Matrix Elites
    - ED Nine.1
    - Idmax 12's

  • #2
    I know that this sounds like a stupid question and you guys are tempted to tell me to , but I have. What I am asking is a very specific implementation question as opposed to a general idea.

    I know that it would be wise to run the monitor off the pc's psu if the psu can handle it, and I know how everything needs to be connected, but I was just wondering if anybody who has done this exact setup can tell me what they needed to buy in addition to both of these products (travla & carnetix)....also, what gauge wires are you guys running???

    I'm sure 18 guage wires are too thin and 6 guage are too thick...
    PostCount++


    - SrCsTc's Bezel
    - Alpine W200/H701
    - ED Nine.2X
    - OZ Matrix Elites
    - ED Nine.1
    - Idmax 12's

    Comment

    Working...
    X