Announcement

Collapse
No announcement yet.

still no xm!

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • still no xm!

    I just downloaded the new FP, never used it...but since I couldn't get MMC to run XM, I'd give it a try. But no go, nothing! MMC says there is no radio hardware, frodo does nothing....I know the xm is getting power because i installed a power light on the inside. But I dont know if its getting any data transmission.
    -Josh
    1997 Mitsubishi Eclipse GSX
    My URL: https://www.facebook.com/jagray85

    XBOX: DarkerStars

  • #2
    It works, do a search for XM and im sure you'll figure it all out. I cant help you as i dont have XM on my pc but i know others here have been using this in FP for a while now.
    01101100 01101001 01110001 01110101 01101001 01100100 01011111 01110011
    01101101 01101111 01101011 01100101

    beer replenishment fund
    http://www.mp3car.com/vbulletin/forumdisplay.php?f=93
    mp3car live search

    i have joost invites, just hit me up for one.

    Comment


    • #3
      I allready did the research. here. I have the XMDirect unit sitting right infront of me. I have the cable made, I've pulled the cable off a few times just to confirm its made right. And still not a damn thing. And its not just frodoplayer, its MMC.
      -Josh
      1997 Mitsubishi Eclipse GSX
      My URL: https://www.facebook.com/jagray85

      XBOX: DarkerStars

      Comment


      • #4
        I had a similar situation with my car pc and xmdirect. I could not get any software to work with it on Com 1. Out of curiousity I installed it on Com 2 and viola, it worked. I found out that the IRQ used on Com 1 was also the IRQ being used on my Rikaline GPS Virtual Com Port.

        Sounds like an IRQ conflict to me, see if anything else is using IRQ 4, if so, change it.

        Hope this helps......

        Troy
        Done!

        If you're into fishing, checkout my website! http://www.pennsylvaniaanglers.com

        Comment


        • #5
          Ok, I only have one serial port. I can change the IRQ's n **** in the bios. And I can change the com port number in Windows Device Manager. I tried changing the com port number, and that didn't work. Uhm....I have the IRQ setting set to Auto in the Bios. There are like 5 settings, None, 3 diff settings, and Auto.
          -Josh
          1997 Mitsubishi Eclipse GSX
          My URL: https://www.facebook.com/jagray85

          XBOX: DarkerStars

          Comment


          • #6
            Before anything, what do you have attached to your USB ports? if you have a GPS what virtual Com port is it on?
            Done!

            If you're into fishing, checkout my website! http://www.pennsylvaniaanglers.com

            Comment

            Working...
            X