when track is starting to play or track is changing... wave volume is set to 100%. Really dont like it... my english is too bad.. maybe i cant describe this perfectly.. but I have two options. Using wave to controll volume by blaupunkt IR or using mastervolume. Master volume controls only front speakers. And wave is set to 100% everytime, when rr starts to play anything...
Master level set to zero when changing volume in RR
I have a similar problem. When I change the volume in RR the master level (the one you can access from the systray speaker icon) is set the zero. If I go into the mixer page in RR and chnages from pop to Rap or similar the volume gets right again. Its a little bit frustrating.
Anyone have a solution to this? Does it have anything to do with the pre-set mixer settings files?
open winamp and check if you have the "AUTO" preset loading on.. if anything just try winamp outside RR and see if the volume behaves in the same manner. There's nothing in RR that will do that. If anything, try the FMOD player in the new RR and see if that happens.
But when I only play .mp3 files all the time, the volume is maintained at say, 20%. Then when suddenly the song switches to .wma, the volume goes up to 100%. I have to manually lower the volume then to 20%. When it changes to another .wma, it goes up to 100% again.
If you get it on winamp ALONE (outside RR), then you need to figure out wha'ts messed up with your winamp... try a different version of it, or uninstall it completely, delete it's folder and re-install to see... if anything, play with the input plugins' settings..