Announcement

Collapse
No announcement yet.

Phoco not starting

Collapse
X
  • Filter
  • Time
  • Show
Clear All
new posts

  • Phoco not starting

    Ok I know you don't support cdma phones, but I have a samsung a900 for sprint . I pretty much had it all working between BT and the data cable I could dial out, it would signal recieving a call (although no call id), and no sms (which I don't use).

    But anyway, phoco now will not start up, the splash screen comes up then it just goes away and phoco is not running. The log file ends at opening com 2, so I was thinking something was wrong with the com port so I went to phone test, and it gives a "port phisically absent" error when I test that port.
    But I can go into hyperterminal and get a response out of it with no problem, I have tried on 2 seperate comps, with fresh installs of phoco and the same thing happens.

    Any ideas???

    -Livin

  • #2
    No one has had this problem???

    Comment


    • #3
      I have the same problem, I have a sgh-z500!!
      Is not possible use phoco and this type of samsung with bluetooth?

      Comment


      • #4
        You both should know that Zorro doesn't offer support for PhoCo in these forums. Take it to the official suport forums for PhoCo.
        Have you looked in the FAQ yet?
        How about the Wiki?



        Under normal circumstances, a signature would go here.

        Comment


        • #5
          See this:
          http://www.mp3car.com/vbulletin/show...434#post724434

          and this:
          http://zhorvat.dyndns.org/PCForums/S...px?PostID=1814

          Comment

          Working...
          X