Analogue inputs acting funny..
I was just about to put my CarPC in my car but I thought I'd test my FB with my simulated steering wheel control circuit and I hooked everything up and noticed that my other ports were measuring a voltage but nothing was there. I took it out and setup a test config file that showed all the ports and their voltages. This is what I got:
In this pic, I have 5v connected to port 1 (Port 1 on FB, Port 0 in configurator) and the other ports are reading these voltages. You will notice that the voltages decrease as the port increases, kinda interesting.
Anyone know why this is? Do I have a fried board? I don't remember doing anything to fry it but who knows. In an attempt to get it to work, I pressed the reset button and switched off power and turned it back on and it said that it was version 3 not 4 when I reinstalled the drivers (I was desperate :nutz:).
Any help would be greatly appreciated!