I have both versions and I have tried searching for the issues here but was unsuccessful. I have programmed some code in VB and I am able to do everything that I need to do but I am dropping out my Fusion Brain when my air compressors kick on. I am thinking it is EMF noise killing them.
The issue is like I pulled the power supply from the Fusion Brain.
I am bench testing it so it is being run off of its own AC/DC power supply and the Compressors are running off of the trucks 12VDC power system. Totally isolated via relays. I am an electrical engineer and controls systems engineer and I design control systems for refineries and chemical plants for a major company. So I am a pretty smart guy when it comes to stuff like this, but this one is kicking my butt.
I also ran into the issue on some solenoids on the same 12VDC power supply. I assumed that they caused the voltage to drop below the threashold that the Fusion Brain needed to stay powered but rulled it out when I separated the power and ran across the same thing.
It causes my VB app to lock up until I cycle the power manually on the FB then it works fine again.
Hit me with any questions you need to know in order to figure this one out.