Thread: Intel D945GCLF (with integrated Atom 1.6Ghz CPU)

Originally Posted by rijk

any chances to XP, any extra installed drivers, usb device, etc ....

No changes to XP at all, just added sevice pack 1 (network install, did not auto update or anything). The only extra drivers I installed were for my USB GPS sensor, and I added a driver to get 800x480 (got it from CarTFT). I am going to have to do some tinkering with the driver as it will not display correctly on my Lilli.... works great on my Samsung 19" though. Still having hibernation in car problems.

What PSU are others using in car with this board?

Originally Posted by BrianFerry

Hello guys, I have the same board, but I can't set 800x480 on it. Does anybody can do this?

I went here, but it doesn't work with my Lilliput 619 - it does work with my 19" though

http://www.cartft.com/support/drivers/Intel_800x480

Originally Posted by Numarc

Hey im also having hibernation problems with my board too. It will boot and come up with the resuming windows loading screen, then it just looses signal. Is this the same problem your having? It seems if I turn the car off and back on it will boot up into my front end (centrafuse).

The issue I am having is that it will not startup at all in the car unless I have just shut it all the way down in the house. I keep having to take it back in to the house to "reset" it.
It did resume perfectly fine last friday night - I shut it down in the house - put it in the car, started it up and I went to get something to eat - came home turned car off and the pc powered down. Came back out to the car about five hours later and it resumed with no problem. So I shut it down and waited about 3min, then I tried it agan and it resumed no problem. I thought all was well. Saturday Morning around 10am I cut the car on to go shopping and it didnt resume. back at square one.

I am thinking that it might be my power supply, but i put my Epia back in on sunday and I havent had any problems.

So then i thought it has to be the BIOS, so I checked that and it is set to S1 - just as my epia is. I tried S3 on the intel just to see - same issue - will not power on.

So the only thing I can think of is that it has to be my car battery.
Maybe I am dropping so low my PS can't handshake. I will get a new battery this weekend. (side note: should have to get a battery as this board takes less power than my epia....but I will)

I am using an opus 120 - same one that has been powering my Epia for almost 3 years.

Originally Posted by klp45

The issue I am having is that it will not startup at all in the car unless I have just shut it all the way down in the house. I keep having to take it back in to the house to "reset" it.

Is the problem always in the morning?

It might be a long shot, but my commell has a tempeture isue, when its to cold it won't start up, run the car so its a bit warmer and it starts up. Just fine.

So if it happends again in the morning, than don't change anything, just start the car and drive it for a while and than try to start up the cpc

Have you tried email costumer support ?

There must be a solution to these problems , because its such a good mb to use as a car pc....

Originally Posted by PORTUGAL

Have you tried email costumer support ?

There must be a solution to these problems , because its such a good mb to use as a car pc....

Heard from Opus - they told me to check polarity of the turn on switch.
I have done that several dozen times.

I'll try intel and see what they say.