power good signal - help me please!
My Super 7 motherboard with an ETEQ chipset (now VIA) needs the power
good signal to operate. I have an Arise 865V DC-DC PSU that does not have
the PG signal. I've tried just tying the +5V to the PG pin (I did it by
soldering on the back of the MB, is that okay??) but it did not work. I also tried a 4.7 K resistor between +5V and the PG as suggested by members of this board in the archives. I did the same thing, just soldering them to the back of the motherboard. Sproggy mentioned something about a capacitor to ground... how does the that fit in? Where do I have to solder all the leads? Thank you!