There sould be no problem with the audio and vidio extentions. You can uy some from maplins for £10. As far is the irman goes you will have problems. The extention of the ir led shouldent be more than a few inches! ater that the signal will be two week for the controller on the irman board to understand. If you do try this you will have to use screened cable. Your best bet is to take the irman circuit out of its box and mount it behind the dash board and extend the wires of the ir led two or three inches so the ir led is sticking out of a hole in the dash. If you dont want alot of wires to the boot then a serial device only needs 3 wires, tx, rx , ground(screen). I would mount the ir led using a led holder in the support for the sun visor in the middle of the car, my curtisy light is next to it so i would mount the irman circuit behind that (there is loads of room). The three wires can then be run dow the front piller to the boot.
Originally posted by ODYSSEY:
<STRONG>I have a question about hacking my IRman. I was wondering if the following was possible or not. Here is what I want to do:
I want to take the Infrared LED from the IRman board and move it about 4/5 feet. This way all I have to do is run three wires from the front to the trunk. Then reconnect the wire to the IRman board.</STRONG>