HOW TO TURN ON LAPTOP IF YOU CANT REACH BUTTON any input device that can turn it on?

**kevinlekiller** · 07-23-2005, 03:50 PM

Its relay that shuts off after a few seconds.

The coil is energized until the cap finishes to charge. Once you stop giving power to 86 the resistor removes the the charge the capacitor built up. This way the next time you give power to 86 the capacitor can build up a charge again.

**MoFo** · 07-23-2005, 09:30 PM

on all 3 laptops that I have opened up, the power switch had 5 or six points on it. It turned out I would always have to short opposite corners. For example: by shorting the top left and bottom right, the power would come on. Heres a pic from the thread I posted earlier:

**kevinbr100** · 07-24-2005, 12:54 AM

first i tested which leads to use on the power switch, then i sautered 22 gauge wire, ran the wire outside the laptop case, add a connector to the 2 wires, ran wire to dash and connected it to onstar switch (i dont use onstar, so thought i would make use of their buttons)

**omlax19** · 07-24-2005, 06:12 AM

OK i got some pics to show you what im working with so if you could show me what to do on one of my pics that would be awsome

also when looking the the pics there are 6 push button switches across the board with are on/off and the email, and music ...but all of the turn on the pc if its of the are numbered 1 through 6 so maybe if i mess up on 1 ill still have 5 others well heres the pics

**omlax19** · 07-24-2005, 06:14 AM

oh yea if all else fails i was just thinkin or running that board to where i need it but there are a ton of wires connected to the back of it

and heres my setup that will be goin in

**Mañana** · 07-24-2005, 11:50 AM

Originally Posted by omlax19

oh yea if all else fails i was just thinkin or running that board to where i need it but there are a ton of wires connected to the back of it

and heres my setup that will be goin in

GO VENTO, GO VENTO, GO VENTO

(called jetta III in the us

)