Thread: FM/DAB digital radio - THAT WORKS!!

Step 4



Step 5



Configure the port

Step 6



Step 7



Step 8



I turn the switch on the radio



And this is the skin that I get. It does not recognize Venice7 and even shows me the skin that you have designed in the forum. What happens?, I'm doing wrong?

Any idea how I can correct the defect?. The plugin does not need a file named with a .xml?

Ok already running. I needed to add the button skin. I mistook the default button that brings Centrafuse Radio FM, AM.

You can remove/ignore Radio AM/FM/HD as this is another type of radio.

Andy

Thanks for your work on the Ultimate DAB centrafuse 3.6 plugin, installed your plugin, linked the button, changed the com port, and that was it, once again a fully working DAB radio in CF 3.5/3.6 !!! After 6 months of getting nowhere with Craig Brass !!

In fact a far better plugin from yourself than the original one from CB for Centrafuse 3.

Once again Thankyou ibf

This device is able to get sound through the USB port. No reason, I think for any drive that I have installed, I'm listening to the radio via the USB port. I can not control the volume but it is clear that it is possible. Anyone who can program and design a drive to the USB port?

How STEREO MONO switch?

Just wondering if it would be possible to have a manual tune option where you can just enter in the frequency of the station you are after?

Thanks for the good work

Originally Posted by Juanito

This device is able to get sound through the USB port. No reason, I think for any drive that I have installed, I'm listening to the radio via the USB port. I can not control the volume but it is clear that it is possible. Anyone who can program and design a drive to the USB port?

This radio does not support audio over USB. The module only has RX/TX/RESET and L/R audio output. The original design use a MAX232 type of chip but this was replaced with the FTDI chip to control the module but Craig did not go further than that. So no USB audio, only a jack out for the audio.

Originally Posted by Juanito

How STEREO MONO switch?

No idea, someone who has the radio should be able to tell you. It maybe be in the menu somewhere.

Originally Posted by Kitiara

Just wondering if it would be possible to have a manual tune option where you can just enter in the frequency of the station you are after?

Thanks for the good work

Not possible with that firmware. It is meant for a clock radio, bedroom radio or kitchen radio. Their function is very limited and the module were meant to be part of a cheap hardware. Its basically a kitchen radio connected to your PC if you like.