Hey Kronos, what do I need to put out to remove the delay function? My car alarm does the delaying, besides I don't want to disconnect the alarm function, as it turns on and off the dome light when arming/disarming and delays 30 seconds after any door has been closed, so if the delay function of your circuit is present, the alarm will think that a door is open and I will have to configure it so it doesn't warn me that there are doors open, and doing this won't let me know if a door is really left ajar. Also, removing the delaying part of the circuit will allow me to build an easier circuit, as I'm a complete newbie with this stuff.
So, I want the circuit to dim, not to delay. What parts do I take out?
Thanks a lot in advance.
can anny one prepare this circut and send it to me i want to fit it in my honda city zx
hello I am new here, hope somebody out there can help me, I have a 06 suzuki grand vitara with j20 engine a/t. normally it had a dome light dimmer delay. but all of a sudden it stopped working, thought it was just a blown fuse but upon checking the fuse out its is in a good shape, oddly though the interior light or the dome light is working properly when you swicth it to on position, aside from the door part. the time when you open the door the interior light does not lit up. also when you turn off the engine the curtesy light comes on before but now it is no longer working. I was told that maybe it was a BCM Body Control Module gone bad. My question is can I use this project to over ride the BCM?
hello Kronos, just came across this forum recently as i am searching for an answer with the same matter, I have a 2006 Suzuki Grand Vitara 4x4 A/T with four cylinder engine J20 to be specific. my car was equiped with this delay and dimming feature plus when you pull out the key from the ignition after shutting down the engine the dome light would automatically come on. But now it stopped doing it, i suspect at first it was just a blown fuse, but to my dismay the fuse is good. somebody told me that i might have a bad BCM which is the Body Control Module, I am just wondering can i over ride the bcm and fit this project? and will this component be enough to light up 3 ten watts incandesent auto bulb? i have two peanut bulbs and one like the dashboard bulb wich is at the laggage compartment. I hope this message can come accross and will be answered. Thank You in advance!