The first post at this thread shows the circuit diagram for adding additional buttons using a resister network. Might be of som help
I have a car pc joycon that is not being used anymore as I have changed cars.
I would like to add some buttons to my car install using this.
any idea how I would wire 4 or 5 buttons using a resistor network implementing this via a car pc joycon?
can I gut a game controller for this?
Thanks in advance.
Thanks very much - looks good - Will have a go this weekend.
Any idea where I can salvage some push to make switches from?
I would rather not buy them :|
almost any momentary, normally open, switch would probably work-- i like to salvage switches from broken electronics, or electronics that i find in the garbage.
My OLD 2001 Mitsubishi Eclipse GT:
"The Project That Never Ended, until it did"
next project? subaru brz