Laptop Touchpad to PS2

**Plecto** · 02-23-2009, 04:51 PM

How du I figure that out? I'll write all the texting on it:

13-NCG1AM062
LOT*16653
TESTED21/05/15

And typed into the metall it says:

13-NCG10M06X

**Plecto** · 02-23-2009, 04:57 PM

I managed to break it down a little. I removed some tape and got out the toucpad only, but without the left and right click buttons (which I would really like to have). We are now down to 10 or 12 connectors (still really small :P). Here it says:

TM61PDE8307
WH526-61
MADE IN HONG KONG (Prolly not relevant :P)

920-000241-02 RevA
SYNAPTICS, INC.

Amazing what you find when you look. On the chip it says T1006G 0512

**Plecto** · 03-15-2009, 06:38 AM

Isn't there any more help to get?

**lbergamo** · 05-24-2009, 12:32 PM

Anyone have any luck with this ? I have a touch pad from an old Dell C610 laptop and I was able to trace the leads from the Synaptics controller. I am just kinda perplexed on how to solder it.

**kenbam** · 05-24-2009, 10:43 PM

http://cgi.ebay.com.au/Trackball-Tou...3%3A1|294%3A30

**lbergamo** · 05-25-2009, 10:43 PM

Why spend money when you do not have to ?

**suburbank2500** · 06-03-2009, 01:07 PM

Originally Posted by lbergamo

Anyone have any luck with this ? I have a touch pad from an old Dell C610 laptop and I was able to trace the leads from the Synaptics controller. I am just kinda perplexed on how to solder it.

Hello

yes i had luck with this.
i buildt it in to my console, and use the touch, and the buttons.

try this link: http://www.synaptics.com/sites/defau...ies/ACF126.pdf

**lbergamo** · 06-03-2009, 09:28 PM

This information was very helpfull. I was able to locate the appropriate pins on the touchpad PCB but what is perplexing me is where to solder. The PCB is very small scale.

**lbergamo** · 06-04-2009, 09:26 AM

Further review of the the touch pad PCB. The PCB looks to be shard with another chip I think handled the little "finger pointing device" recessed in the keyboard. This is complicating things for me. Below I have included some images of what I am dealing with.

Top ( Left to right ): Touchpad PCB, Touchpad PCB with pins traced...
Bottom ( Left ): Close up of the touchpad PCB with pins traced...

**suburbank2500** · 06-04-2009, 10:30 AM

Originally Posted by lbergamo

Further review of the the touch pad PCB. The PCB looks to be shard with another chip I think handled the little "finger pointing device" recessed in the keyboard. This is complicating things for me. Below I have included some images of what I am dealing with.

Top ( Left to right ): Touchpad PCB, Touchpad PCB with pins traced...
Bottom ( Left ): Close up of the touchpad PCB with pins traced...

is the two buttons (right\left)at this pcb, ore separated.