I have a eby701-np c t that I have taken apart to fit into a 2x din.
I have it hard wired but noticed that it's constantly on (standby mode).
It's working fine but now i want to place a switch in between.

However, I can't get it to work.

When I connect +/- to the distribution block +/- it works fine.
It even works when I only connect the + and not the -.
Now when I properly wire the switch it does not work at all.
I'm really lost and stumped.

I connected the + of the screen to the accessory of the switch.
And connected the +/- of the switch to the +/- of my car. The - of the screen is grounded as well.
And nothing happens. The switch is fine I tested it with other things.

Anyone have any suggestions?