Auto Switching on my Lilliput is acting VERY funky.. Help Please..
So I have a model of Lilliput that has the green wire for autoswitching. I hooked it up to my reverse wire and tested it successfully in my garage (with the the car on, but not started)..
The next day I turn on my car, hit the brake, and the monitor flickers.. I put it in reverse and it correctly goes to VIDEO2 and I get my camera.. However, there are big red lines down the right side (something I've never seen on my LCD before)..
I put it in drive and it does back to DVI, as it should.. Then red lines go away after a few seconds.. The first time I hit my brake it goes to VIDEO1 (I believe) for a second and then goes back to DVI (even though I still have the brake pushed in)..
When I turn on the turn signal it does the same thing.. When I have the turn signal AND the brake pushed in it flickers from VIDEO2 / DVI very quickly.. WTF!?
My test light shows the wire I'm tapped to is only 12V when the reverse light is on.. How is this happening?