Backup camera help / How to connect RF wire? PLEASE!
OK here's the story. I bought a lilliput 629gl on here years back for my carpc. I eventually took out said PC but left the screen in my car. Currently it's not being used by anything. Because of lack of money, I cut off the bottom of the screen bezel where the buttons / rf receiver is and gorilla glued it to my bezel in my WRX instead of buying double DIN brackets. (I know its stupid but I had no money) It worked out very well actually as far as the screen being secured.
Here's the problem: I bought a backup camera and installed it. Connected the yellow composite cable to the lilliput but the screen is still set to PC from when the carpc was in there and won't display anything because it's connected via Composite and not VGA. AND, to top it off, I cant change the input because the bottom of the screen where the buttons are, along with the rf receiver had been cut off (and discarded)
I bought this from MoCoSo: http://www.mo-co-so.com/Pre-Wired-IR...cs-lil-rir.htm
Is there any way I can connect that to my screens board so I can utilize the remote control and change the setting to Video1 or whatever?
So, in this picture: http://store.mp3car.com/v/vspfiles/a...s/ir+board.jpg
I have the blue wire with RF attached, but not that board.
Any suggestions?? Thanks in advance!