Results 1 to 2 of 2

Thread: question about hooking up my bare LCD....

  1. #1
    Maximum Bitrate jusatry's Avatar
    Join Date
    Nov 2003
    Posts
    862

    question about hooking up my bare LCD....

    I recently purchased a sharp LQ10D367 panel with an M1023 Rev E controller card. When i am hooking it up, the VGA monitor cord terminates on the controller end in jumpers and the sheilding comes to a ring-terminal. Obviously the sheilding is the ground for the VGA signal, but the power jack is also on the monitor plug. Do What do i have to ground this ring-terminal to? There is a mounting hole on the board - but it doenst look like it is grounded to anything. Where does this terminal (monitor sheilding...) need to be grounded to?

    Anyone with any notes on hooking this up for a first timer? I dont want to break it before i even use it

    Also, there is (what appears to be) a small crack in the screen - it is darker on a very thin line for about 4 inches - will the LCD panel not work at all, or just in that area?

    Thanks!

  2. #2
    Maximum Bitrate jusatry's Avatar
    Join Date
    Nov 2003
    Posts
    862
    bump?

    anyone with some experience?

Similar Threads

  1. question about an LCD and controller
    By Shaar in forum LCD/Display
    Replies: 2
    Last Post: 03-21-2004, 09:19 PM
  2. Is a Bare Sharp LCD worth it?
    By c0rrupti0n in forum LCD/Display
    Replies: 3
    Last Post: 03-14-2004, 08:05 PM
  3. SBC to LCD question
    By Frogbutt in forum LCD/Display
    Replies: 1
    Last Post: 06-17-2002, 05:22 PM
  4. Hooking up a 12.1" Laptop LCD
    By Griff1324 in forum LCD/Display
    Replies: 2
    Last Post: 11-16-2001, 06:03 PM
  5. Question about hooking up an LCD
    By chris in forum General Hardware Discussion
    Replies: 10
    Last Post: 12-21-2000, 09:11 AM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •