Thread: Intec PSOne LCD Pin outs....Success!!

This makes me wish that I got the 5" version of the Intec screen. The 4" version (which I have) is composite only. Two wires go from the daughter board that plugs into the PSOne to the controller card that plugs into the LCD. No analog RGB conversion stage.

Originally Posted by tom61

This makes me wish that I got the 5" version of the Intec screen. The 4" version (which I have) is composite only. Two wires go from the daughter board that plugs into the PSOne to the controller card that plugs into the LCD. No analog RGB conversion stage.

I bought a JOYTECH XBOX screen thinking they are better suited for mods.

After I saw the capacitors poorly soldered on, much worst than the one you shown on the other thread I quickly put it together and returned it to the shop

The picture quality is also crap anyway so

Hey Tidder...where did you get your screen? is it new? is it just the screen?

I wanna buy one to play around with

do u have a link tiddler

Hey Guys,

Sorry I haven't been good about watching this thread. A bunch of you have contacted me directly. So here is an update on where I am at.

i have almost finished putting together the C-Sync circuit and will begin testing its output to the screen. I will take Pics and post them in a new thread. I have a couple of contacts, that are also working on the same mod. One guy is tring to locate the V-Sync and H-Sync directly on the board. I am going to go forward with the 10 pin connector. Hang with me, i am trying to get this working for all of us.