xenarc white screen then shut off

**SexualChocolate** · 09-22-2005, 04:05 PM

So previously my xenarc 700ts (newer version with black buttons) was working. However, I removed the back casing and disconnected those 2 wires to the capacitor (at least I think thats what it is, it says 32 ohms) so i could glue the back casing to my dash. Now that its glued, I resoldered those two wires and screwed the casing back together. However, when I turn it on, the screen slowly turns completely white, then after about 10 secs it shuts off and the light blinks like its in standby. When I change the input mode, it doesnt show "AV1" or whatever on the screen like it had previously (Theres nothing hooked up to it, but I dont think that would matter). The same goes with changing the volume.

So does this sound like the ribbon cable issue, a problem with my soldering or something different?

Thanks

As your looking at the capacitor (i think), if you look from where it says 32 ohms, i soldered the black wire on the left and the red on the right. I'm pretty sure that was right but I didnt take a picture or anything to remember.

**SexualChocolate** · 09-22-2005, 06:23 PM

Alright, I've resoldered those two wires and now the menu shows up when I press the buttons like it should, but the white text (ie "PC" or "AV1") changes through several colors. Then after 10 seconds it says "Power off" and shuts down like it did before.

edit: the text no longer changes to several different colors. The only problem is the unit shuts off after 10 sec. I'm not sure if its a power problem or if it shuts off as a safety precaution so nothing gets damaged.