LinkBack URL
About LinkBacks
Reply With Quotebumpity bump.
I'm having a very similar problem. I have a Xenarc 700 TSV powered off of an OPUS POL off the acc line. turn on on the OPUS is hooked up to my HU's amp line, so the screen turns on and off with my HU (which is nice).
was working fine for a while. Now it's got problems. If I'm starting it first thing in the morning, or after work (when the car / system has been off for a while) then it boots up and screen powers on normally. If, however, I drive for a bit, turn off the car / system (like eating dinner / buying gas) and turn it back on, then the following happens:
(I resume from hibernate) boot screen, then hibernate loading screen, then as soon as windows loads, the screen stops receiving signal and powers off. Then I get the ding-dong of the touchscreen USB powering off. Computers still running fine -- music still plays, GPS still works, etc.
Again, this only happens when the car has been recently run. And I pulled the computer and hooked it up to a monitor on my desk and it works fine.
The only thing I can come up with is that it's some kind of overheating issue. But the screen will happily run for hours and hours on a road trip. It's only when I power cycle it that I get problems (and not always -- just 50/50)
I'm going to try your thing of waiting to power on the screen after windows fully loads. Hope that helps. But does anyone else have any bright ideas?
Bookmarks