Help! Lilliput changed input, I am missing buttons
When I installed my 8" Lilliput, I molded it into my dash, and then I set it up for VGA input, and programmed it using the remote to auto-power on. Since it was always powering on, and always powering up to the VGA input, I un-plugged the circuit board that contains the buttons and IR sensor. I recently have been having a power problem where my powersupply won't supply enough power at startup to run all of my devices. So I have been popping the fuse out of the Lilliput "egg" (or box in the case of the 8") until the PC boots up, then putting the fuse back in, allowing the screen and all the devices (and the screen) to be running while the computer is on. This morning, I did that, but when the screen came up (usually with "VGA MODE") with "VIDEO-1", then s small green and white box saying "C-VIDEO no input". I believe the screen switched from auto-sensing the VGA input to auto-sensing the composite input. Since I no longer have the buttons or IR eye attached to the screen (it got thrown out) is there any way to switch it back to VGA? Does anyone have a broken 8" lilliput I can buy the button circuit board from? Please help! Thanks!