Lilliput 8" touch screen backwards - FC4
I recently installed Fedora Core 4 on my Mac Mini, and am using a Lilliput 8" touch screen on it. It detects the touchscreen as an eGalaxy screen, and installs the touchkitusb kernel module for it. However, the X and Y axis seems to be backwards: When I touch on the top left corner of the screen, the cursur goes to the bottom right corner of the screen.
Thinking it was an Endianess problem (i.e. intel vs. ppc) I tired it on an intel fedora core 4 system, and the same thing happens!
Does anyone have any ideas? I am about to dive into the kernel module itself and attempt to figure it out, but I've seen other posts where people have this same screen working fine under Linux. Is it possible this is a newer model (just purchased) and is a bit different? Has anyone else had this problem?
By the way, when I boot into OS X and install eGalaxy's drivers, it works just fine, so it isn't the hardware.
Same problem with the 7" Version
It seems I have exactly the same problem. FC4 and the touch screen is not setup correctly. I had a look at the xfree86 howto regarding calibration but am consusfed becase I can't find a xorg.conf version.
Have downloaded the FC3 driver and am ready to go!
Lilliput 7" Touch - EPIA 500 - FC4 - NMEA Serial GPS