Warning: Declaration of vB_ProfileBlock_vBSEOLikes::block_is_enabled() should be compatible with that of vB_ProfileBlock::block_is_enabled() in Unknown on line 0
View Profile: Jensen2000 - MP3Car.com

under nav bar

About Jensen2000

Basic Information

About Jensen2000
Biography:
Stephen Jensen
Car Details:
1996 BMW M3
Location:
Seattle, Washington, USA

Signature


Have a product you would like to sell on the mp3Car Store? PM me for more information.

Have a car computer question? Ask me by emailing the store.

Statistics


Total Posts
Total Posts
291
Posts Per Day
0.14
Albums
Total Albums
5
Total Photos
61
General Information
Last Activity
Today 04:14 PM
Join Date
02-04-2009

4 Friends

  1. ChasPhillips ChasPhillips is offline

    Administrator

    ChasPhillips
  2. Fiberoptic Fiberoptic is online now

    is back. FKA Robert Wray

    • Send a message via ICQ to Fiberoptic
    • Send a message via AIM to Fiberoptic
    • Send a message via Yahoo to Fiberoptic
    • Send a message via Skype™ to Fiberoptic
    Fiberoptic
  3. JohnWPB JohnWPB is offline

    Super Moderator

    • Send a message via Yahoo to JohnWPB
    JohnWPB
  4. optikalefx optikalefx is offline

    Antenna Engineer

    • Send a message via AIM to optikalefx
    optikalefx
Showing Friends 1 to 4 of 4
View All Images
    My Photos
View Jensen2000's Blog

Recent Entries

Car Computer Install: Backup Camera Installation

by Jensen2000 on 06-06-2012 at 03:59 PM

Embed this video


Sean shows us how to install a backup camera with a Lilliput monitor pre-wired for backup camera connectivity. These special Lilliput monitors have a wire (usually green in color) that extrudes from the back of the circuit board. When this wire receives +12V, the monitor automatically switches from your PC input to AV2, where your camera is connected. So, if you connect this wire to your backup lights and your camera to AV2, when you shift into reverse, the display will switch to your camera input.

Car Computer Install: Noise In The System

by Jensen2000 on 04-12-2012 at 02:10 PM

Embed this video


Sean discusses problems with noise in the system and ways to eliminate them.

Car Computer Install: First Boot

by Jensen2000 on 03-26-2012 at 04:34 PM

Embed this video


Sean boots up his car computer for the first time. Be sure to make sure all positive wiring is connected to the appropriate accessory or capped with electrical tape before you reconnect the positive power cable to your battery. With any luck, your computer should boot properly the first time. Sean's enthusiasm on the video is testament to the difficulty associated with any car computer installation and his relief is apparent when everything works properly.

Car Computer Install: Wiring The Dash Overview

by Jensen2000 on 03-01-2012 at 06:02 PM

Embed this video


Sean goes over all of the wires that go into the dash from the computer, amplifier, and other peripherals. The BoomzBox is also installed into the dash behind the monitor. This is secured to the frame of the dash with adhesive tape and large zip ties. Backup camera wiring is extended to the backup light. When this wire gets +12V, the Lilliput monitor will automatically switch from PC to AV2, displaying the backup camera through this input. A vehicle specific wiring harness eliminates the need to splice into your factory wiring.

Free Shipping In March

by Jensen2000 on 03-01-2012 at 02:13 PM

SHOP NOW


This promotion is good for orders more than $20 shipped to the lower 48 states.
Categories
Store Sales

0 Likes