I have the BT-328 Bluetooth GPS Receiver by GlobalSat.
I also have a IOGear USB Bluetooth Chip
Windows 7 Ultimate with a Widcomm Bluetooth stack.
When I pair the device with the computer it assigns two virtual serial ports, ports three and four.
Three is incoming, four is outgoing. Both are set the Baud Rate of 38400 as per GlobalSat instructions.
When I go into S&T 2010, and tell it to detect the ports, it detects port three, says the GPS is on it. But when you go to start the GPS in S&T it says the port is available, but is not sending any data. How do I fix this problem? Please and thank you.