Thread: Are you using new wire for your new speakers?

i believe that you should replace the wire in the car because you will not get near teh bass or quality out of the stock wires. i have changed all the speakers in my 1992 grand prix gtp and have noticed that you cant get the quality or bass you should have out of your speakers with their stock wires.

thank you for your recommend, I just changed the wires, and now. I am waiting for the amp comming, so I can try it. and I am looking for a subwoofer, you guys think what sub I should go for and how many W I need for the amp. thanks

I like both alpine and jl audio (favorite 2 12w3) just make sure that the amps rms matchs the subs rms and that the amps peak isn't higher than the subs peak ( you can always turn the gain on the amp down)

I have 1 more question, If I buy a 1000W or 1200W, then how many W of the amp I need to buy, thanks, and how many channel ?

is that the rms or peak? if you want but two amps one for each sub then get 2 mono (1 channel (D)) amps but if you want to use one amp then get a 2 channel amp. from what your saying the wattage is i think you would be better off getting two amps, but it all depends on how you want to wire your subs. if you tell me what ones you plan on getting i think i could be of more help to you.

.....right now, I have 2 front Pioneer and 2 6x9 boston's speakers for the back, and I just bought a amp kenwood Wood KAC-629S 2 channel. and do you guys think it enough for that speakers? then I am planning to buy 1 more amp and the subwoofer.

here is the amp I have right now:

2-Ohm Stable
Power Indicator
Screw-Type Power and Speaker Terminals
Speaker Relay Protection
THD at 4-Ohm RMS Power: 0.08%
Speaker Level Inputs
Built-In Crossovers: HP/LP
Frequency Response: 20-20,000 Hz
Signal to Noise Ratio: 100 dB
Dimensions: 9 7/8 L x 11 W x 2 5/16 H